Metal Roof Panels

Metal Wall Panels

Trim Specialties

Distribution Materials

   MRS System 3000

  • ASTM E1592, E1646, E1680 Tested
  • U.L. 580 Class 90 Certified
  • Ideal for Low Slope Conditions in Commercial Projects
  • Mechanical Locked to Ensure a Water-Tight, Integral Design
  • Can be Formed Using 22/24 Gauge Steel and .032/.040 Aluminum
  • Optional Sealant in Batten Cap
  • Panel design Accommodates Thermal Movement.
Technical Data
Product Data Sheet
Flashing Details
UL 580, UL 790, UL 2218
Watertightness Warranty
Finish Warranty
Color Chart
Seamer Rental/Info
    Product Data  

12" to 18" O.C.
22/24 ga.
.032 aluminum /.040 aluminum

Panel Features
Striations - Recommended
Optional Sealant in Batten Cap

Panel can be installed on Solid Substrate or Open Framing
Ice & Water Shield or Synthetic Underlayment
Minimum Roof Pitch: 1/2" on 12"

Kynar 500® or Hylar 5000®
Two-Coat Fluropolymer

System 3000
MRS System 3000 Panels are factory-formed to specified lengths and field seamed with batten cap. MRS System 3000 panels are available in 12"- 18" widths, in either 22/24 ga or .032/.040 aluminum.

Radius System 3000
System 3000 panels can be curved at the factory or on the job site depending on the radius and length of the panel.

UL 580, UL 790, UL2218 Certified
MRS System 3000 panel carries a UL 90 classification over solid substrates and open framing. Solid substrates include Plywood, OSB, Rigid Insulation, Gypsum Board etc.

Structural Performance
MRS System 3000 panel was tested and observed to meet the performance requirements of the ASTM E1592 for structural performance of metal roof and siding systems.

Air and Water Infiltration
MRS System 3000 panel meets the performance requirements of the ASTM E1646 Air Infiltration test and the & ASTM E1680 Water Penetration test.

  LEED Credits

If applicable Metal Roofing Systems, Inc. can provide LEED Information when requested. For information on state and local tax initiatives, please go to USGBC Government Resources page.

LEED: SS Credit 7.2 Heat Island Effect: Roof
Requirement: Roofing materials having a Solar Reflectance Index (SRI) equal to or greater than the values below for a minimum of 75% of the roof surface.

Low-Sloped Roof (<=2:12): SRI must be >= 78% (2 colors available)
Steep-Sloped Roof (>=2:12): SRI must be >= 29% (29 or more colors available)

LEED: MR Credit 4.1 Recycled Content
Our material contains the following recycled content:

Galvanized Steel: Recycled scrap represents some 31% of the finished product.
23% of this is Post-Consumer
8% of this is Pre-Consumer

Aluminum Products: Recycled scrap represents some 88% of the finished product.
35% of this is Post-Consumer
53% of this is Pre-Consumer

LEED: MR Credit 5.1 Regional Materials
To qualify the materials being used on the building must have been extracted, havested, or recovered, as well as manufactured, within 500 miles of the project site for a minimum of 10% of the total materials value.

Please contact Metal Roofing Systems to find out if your project will qualify for this LEED credit.

© 2013 Metal Roofing Systems