Metal Roof Panels

Metal Wall Panels

Trim Specialties

Distribution Materials

   MRS System Tee

  • Low Profile Design Ideal for Transitional Mansard and Fascia Applications
  • Non-Directional Panels Perfect for Challenging Projects
  • Available in 1" and 1 1/2" Heights
  • Radius Profile Available
  • Can be Formed using 22/24 Gauge Steel, 16 oz Copper, and .032 Aluminum
Technical Data
Product Data Sheet
Flashing Details
Finish Warranty
Color Chart
    Product Data  

Product Overview
MRS System Tee is a non-structural panel featuring a seam cap. A concealed clip locks the batten to the panel allowing for contraction and expansion. MRS System Tee panels are designed for use in roofing, mansard and fascia applications and a minimum 3:12 roof pitch. MRS System Tee panels can be tapered or curved to meet radius specifications.

12" to 20" O.C.
22/24 ga.
.032 aluminum
16 oz. Copper

Panel Features
Stress/Stiffening Ribs

Panel can be installed on Solid Substrate
Ice & Water Shield or Synthetic Underlayment
Minimum Roof Pitch: 3 " on 12"

Kynar 500® or Hylar 5000®
Two-Coat Fluropolymer

  LEED Credits

If applicable Metal Roofing Systems, Inc. can provide LEED Information when requested. For information on state and local tax initiatives, please go to USGBC Government Resources page.

LEED: SS Credit 7.2 Heat Island Effect: Roof
Requirement: Roofing materials having a Solar Reflectance Index (SRI) equal to or greater than the values below for a minimum of 75% of the roof surface.

Low-Sloped Roof (<=2:12): SRI must be >= 78% (2 colors available)
Steep-Sloped Roof (>=2:12): SRI must be >= 29% (29 or more colors available)

LEED: MR Credit 4.1 Recycled Content
Our material contains the following recycled content:

Galvanized Steel: Recycled scrap represents some 31% of the finished product.
23% of this is Post-Consumer
8% of this is Pre-Consumer

Aluminum Products: Recycled scrap represents some 88% of the finished product.
35% of this is Post-Consumer
53% of this is Pre-Consumer

LEED: MR Credit 5.1 Regional Materials
To qualify the materials being used on the building must have been extracted, havested, or recovered, as well as manufactured, within 500 miles of the project site for a minimum of 10% of the total materials value.

Please contact Metal Roofing Systems to find out if your project will qualify for this LEED credit.


© 2013 Metal Roofing Systems